Self-Tests; Running Parameter Tests - Philips Vari-lite VL3500 Wash User Manual

Self-Tests

Running Parameter Tests

The luminaire is capable of running self-tests by using the
When running tests on multiple luminaires, a male termination connector is required at the last
luminaire in the link. Refer to
regarding the construction of this connector.
Note: After 10 seconds of inactivity, the menu display changes to the default state showing the
address.
To connect luminaires for simultaneous testing:
Step 1. At last luminaire, install male termination connector into DATA THRU XLR connector.
Step 2. At master luminaire Menu Display, press [Menu].
WARNING: Light Beam Projects Intense Heat
Do not illuminate objects within 3.5 m (11.5 feet) of the VL3500™ Wash Luminaire. Objects within
this range can scorch, melt, or ignite from the heat projected by the light beam.
To run tests:
Step 1. Press [Menu].
Step 2. Press [Up] / [Down] arrows until
Step 3. Use [Up] / [Down] arrows to select a parameter to test. Refer to
Chart" on page 53
Step 4. Press [Enter] to run test.
Step 5. Press [Menu] to stop test at any time.
02.96 86.000 1 B
"Connecting Data and Power" on page 18
Master Luminaire
AC PWR
~
DATA IN DATA THRU
AC IN
MENU ENTER
Data Thru
Figure 4-2: Testing Setup
for a complete list of test parameters which can be chosen.
Test
Luminaire 1
AC PWR
~
DATA IN DATA THRU
AC IN
MENU ENTER
Data Thru
appears. Press [Enter].
Test
01 J un e 20 09
M S : S -T
ENU YSTEM ELF
menu functions.
for more information
Luminaire 2
AC PWR
~
DATA IN DATA THRU
AC IN
MENU ENTER
Termination Connector
"Menu System Function
4
ESTS
59