Maintaining The Filter - Panasonic EH-NA30 Operating Instructions Manual

Maintaining the filter
•
Clean only after turning off the power and removing the power
cord from the power outlet.
•
At least once a month, when dust etc. has built up, detach the
filter from the hair dryer and remove the dust etc. using a
toothbrush or vacuum cleaner.
•
Use a commercially available toothbrush.
1. Pull on the catch on the bottom
side of the filter to detach.
. Remove any dust etc. adhered to the filter or air inlet.
•
Remove the dust etc. adhered to the outside of the filter
using a vacuum cleaner. If this does not remove the dust,
use the thick part of your fingers to push the dust etc.
through the fine mesh on the internal side towards the
metal mesh on the external side, and scrub away carefully
with a toothbrush.
•
Using the toothbrush, carefully scrub away any dust etc.
from the internal side of the filter.
•
Using a vacuum cleaner or toothbrush, carefully remove
any dust etc. adhered to the air inlet.
* Rubbing forcefully with your nails may tear the filter, so
please use a toothbrush.
6
3. Attach the filter securely, starting
with the upper side.
•
Keep pressing until you hear
a "click" from both upper and
lower catches.
Notes

•
Only qualified personnel should repair or disassemble the hair
dryer.
•
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent, or similarly qualified persons
in order to avoid a hazard.
•
If the cord or plug is damaged, stop using it immediately and
contact an authorized Panasonic service center.
•
When the hair dryer is blowing hot air, occasionally air may
turn cool or sparks may be seen. In such cases, dust may
have accumulated at the air inlet and/or the air outlet. Also,
the air inlet may be being blocked by your hair, hands, etc.
(This phenomenon is the result of the hair dryer's thermal
switch. The sparks do not pose a danger in and/or
themselves.) Slide the main switch to the "0" position and
remove any dust that has accumulated.
•
If sparks occur inside the nanoe™ outlet, the electrodes have
become dirty resulting in abnormal discharge. If this happens,
clean the inside of the nanoe™ outlet.