Information For Dry Use Vacuum Cleaners - Numatic Henry HVR 200-12 Owner's Instructions Manual

Ensure you read the instruction manual before using the machine.
Operators shall be adequately instructed on the use of these machines, as with all
electrical equipment, care and attention must be exercised at all times during use,
you must also make certain that routine and preventative maintenance is carried out
periodically to ensure safe operation.
WARNING
Failure to carry out maintenance as necessary, including the replacement of parts
to the correct standard could render this equipment unsafe and the manufacturer can accept no
responsibility in this respect.
This machine is for DRY USE only
You must disconnect the machine from the mains by removing the plug from the supply socket
BEFORE cleaning or maintenance and when replacing parts or converting the machine to another
function.
This appliance is intended to be assembled, cleaned and maintained by an adult.
This machine is not suitable for the collection of biological hazards, hazardous or explosive dusts.
Contact your local distributor if you require a machine capable of performing these tasks.
This machine is not a toy; children shall not play with this machine.
The machine must not to be used by persons with reduced physical, sensory or mental capabilities,
or lack of experience or knowledge, unless they have been given supervision or instruction.
You must not allow the supply cord to come into contact with rotating brushes (if fitted).
Only use the socket outlet on the machine for purposes specified in the instructions (where fitted).
This machine must not be stored outside, or used in wet environments, or to collect
wet materials.
The vacuum cleaner should be stored in a dry place and is for indoor use only.
You must ensure that the filtration system fitted to the machine is suitable for the
material being collected.
CAUTION
NOTES
This product complies with the requirements of EN 60335-2.69 2012.
The primary use for this machine is commercial, for example in hotels, schools,
hospitals, factories, shops and offices.
If the vacuum cleaner stops working, remove the plug from the wall before investigating where the
fault lies.
If the vacuum cleaner has a blockage, switch off, remove the plug from the socket outlet, and
inspect the floor tool, wands and hose for debris. If the floor tool, wands and hose are clear, replace
the dust bag and clean the filter.
The vacuum cleaner should be inspected after use for damage.
The power light will illuminate, when your machine is connected to a suitable power supply (where
fitted).
● Keep your machine clean.
● Keep filters clean.
● Use filter bags, they will enhance performance and help keep machine clean.
● Use a Numatic original filter bag under fine dust conditions.
● Keep hoses and tubes clear.
DO
● Replace any worn or damaged parts immediately.
● Regularly examine the power cord. If damage is found such as cracking or ageing the
power cord must be replaced by a competent person using the correct Numatic original part.
● Change dust bag frequently.
● Keep diffuser filter (where fitted) clean.
● Only use the brushes provided with the machine. The use of other brushes may impair safety.

Information for dry use vacuum cleaners