Download Print this page

Maytag MDB5010AWA User Manual page 10

Advertisement

Operating
"tips .......................................................
Starting
The Dishwasher
Adding
a Forgotten
Item
B
After loading the dishwasher and adding detergent,
For best cleaning, the forgotten item should be added
set the control knob to the desired cycle and press
early in the cycle.
the appropriate option button(s).
[]
Unlatch the door.
[]
Run the water from the hot water tap to clear the
[]
Wait for the water circulation to stop.
line of cold water before starting. Connect convert-
ible models to the faucet. (See below)
[]
Open the door and add the item.
[]
Press the door until it latches. The cycle will begin
[]
Close and latch the door.
with a drain prior to fill.
[]
The cycle resumes automatically.
.......
)S_ separately or together_
NOTE: W_
heating _
a_ i6_i:oh_ _a h be
oeeoollweomeoo
Indicator
Lights
Delay Start glows when this option is selected. The
"_ Clean (select models) glows at the end of the dry
light stays on until the start of the cycle,
cycle and remains lit until the control knob has been
On (select models) glows when any cycle on the control
manually advanced to OFF.
knob (including delay start and dry) is on. This light will
_-_Heating Delay glows to indicate that the cycle is
go off when the control knob reaches OFF.
being extended to heat water to the proper temperature.
The location of the _ symbol around the knob corre
sponds to the heating delay portions of the cycle.
oeolllool*oeool*
Connecting
a Convertible
]
Turn on the faucet at the sink until hot water comes
out. Turn off the faucet.
]
Pull the connector from the recess in the back of the
dishwasher as shown.
]
Press down on the thumb release and lift the con-
nector onto the faucet.
]
Remove pressure from the thumb release and tug
slightly on the connector to be sure it is securely in
place.
_I_ Turn the hot water on full force.
]
Check that the sink drain is open so water from the
dishwasher can drain properly.
B
Pull the electrical cord from the recess. Plug it into
a properly grounded outlet.
]
Select the proper cycle for the load and start the
dishwasher.
Release
Faucet
Button
Connector
9

Advertisement

loading