Noise Cancel; Choosing A Noise Cancel Channel; Noise Cancel Channel - Kellyco Minelab X-Terra 70 Quick Start & Reference Manual

NOISE CANCEL

34
The detector may become noisy or
erratic due to electrical interference
from powerlines, electrical equipment
or other detectors operating close by.
This interference is interpreted as a
crackling or popping noise.
Noise Cancel allows you to change
the noise cancel channel so that you
experience less interference. Five
channels are available, represented by
the numbers -2, -1, 0, 1, 2, and are also
indicated on the menu scale.
It is best to choose a channel with
the coil in the detection (horizontal)
position because interference received
in a vertical position may be different
from the interference received in the
horizontal position.
The coil should be held in the air and
away from large targets when changing
Noise Cancel channels.
There is no loss in depth or Sensitivity
if the Noise Cancel channel is changed.
Manual
Press and choose Noise
MENU SELECT
Cancel.
+ –
Use the and buttons to select the
quietest Noise Cancel channel.
Press , to return to
PINPOINT DETECT
detection.
Auto
Press and choose Noise
MENU SELECT
Cancel.
Press to activate Automatic
MODE AUTO
Noise Cancel. The letters AU will
appear and the menu scale segments
will be animated as a progress bar.
Keep the detector still while this is
occurring. After 15 seconds, the
detector will automatically select a

Noise Cancel channel.

Press , to return to
PINPOINT DETECT
detection.
Auto Noise Cancel will always
choose the channel with the least
amount of noise. This may change
each time Auto is used.
During Auto Noise Cancel,
all button presses are ignored.

CHOOSING A NOISE CANCEL CHANNEL

35