Motorola CP110 UHF User Manual page 49

• 1 and 2 or,
• 3 and 4 or,
• 5 and 6 (*).
When cloning, the MUC does not need to be
plugged into a power source, but ALL radios
require charged batteries.
1. Turn ON the Target radio and place it into one of
the MUC Target Pockets
2. Power the Source radio following the sequence
below:
• Long press the PTT button and SB2
simultaneously while turning the radio
ON.
• Wait for 3 seconds before releasing the
buttons until a distinctive audible tone is
heard.
3. Place the Source radio in the source pocket that
pairs with the target pocket you chose in step 1.
Press and release SB1.
4. After cloning is completed, the Source radio will
sound either a 'pass' tone (cloning was
successful) or a 'fail' tone (cloning process has
failed). The 'pass' tone sounds like a good key
'chirp' whereas the 'fail' tone sounds similar to a
'bonk' tone. If the Source radio is a display
model, it will either show 'Pass' or 'Fail' on the
display (a tone will be heard within 5 seconds).
5. Once you have completed the cloning process,
turn the radios OFF and ON to exit the 'cloning'
mode.
• If cloning fails please refer to "What To Do if
Cloning Fails" on page 49.
47
English