Emtying The Cloth Dust Bag; Changing Or Cleaning Of The Brush - Parish Supply TRIUMPH 12S - 86064 Instructions For Use Manual

5.2 Emtying the cloth dust
bag
5.3 Changing or cleaning of
the brush
14
Empty the Bag whenever the "Bag Full" Light (10) comes on. To empty
or to replace:
1. Remove cloth bag as above in steps 1-3.
Disconnect the power cord from the electrical outlet. Pull the Dust
lid button (11) and remove the Dust lid outwards to remove it from
the cleaner.
2. Push downwards at the edge to the left of the plastic holder, so that
the bag loosens from the vacuum inlet of the machine.
3. Grasp at the plastic flange of the bag and gently pull the bag out-
wards - away from cleaner.
4. Remove bag clip and shake out bag contents.
5. Put the bag clip back on the bag.
6. Replace clean/new cloth bag into machine and close back cover as
above in step 4-6. Insert the cleaned/new cloth bag into the slot of
the bagholder and push the bag in place so that bag is secured.
7. Push the bag holder with the new bag upwards, so that the bag
inlet fasten to the inlet of the machine. Make sure that the bag is
unfold and will fit in place at the bag housing. Also check that the
"no bag" clip is placed to the left so that the lid will be able to close.
8. Fit the two notches of the back cover to the two slots at the lower
part of the bag housing, and push the back cover back in place at
the housing.
• Photos shows changing of the paper dust bags!
Never operate the machine without a Dust Bag in place.
• Always disconnect the power cord before performing any
machine maintenance.
CAUTION
WARNING
1. Unplug the power cord from
the electrical outlet.
2. Release the brush roller
by unlocking the bearing
block. Push the button down
towards the unlocking symbol
at the brush housing.
3. Grasp at the bearing block
and pull it out from the brush
housing.