Table of Contents
Advertisement
Before installing your FastFrame adapter, you must configure your system to recognize it by installing drivers for
your operating system.
Note
If you already have one or more FastFrame
adapters installed and you are installing
additional adapter(s), you do not need to
perform any of these procedures unless you
are updating a previously installed driver.
Windows
Note
Windows 8 and Server 2012 R2 may
utilize a new User Account Control
Feature. Because of this there may be
additional confirmations that will need to
be performed to properly install the driver.
These confirmations normally consist of a
dialog where the user has to give Windows
permission to perform an action. If you do
not have the correct privileges during this,
you will be prompted for an actual user
name and password. You may need to
contact your system administrator if you
do not have this information.
1
Power on your system and log in as the
administrator or a user with proper
administrative privileges.
2
Go to
https://www.attotech.com/downloads/
3
Register or log in if previously registered.
4
Click on Ethernet Adapters in the left dialog.
5
Navigate to your HBA model/family in the right
dialog and click on it.
6
Scroll down to and click the desired driver
depending on the operating system.
7
A download window appears. Choose Save
File.
8
Double-click the downloaded file to extract and
launch the driver setup program.
6 ATTO Technology Inc. FastFrame NIC Installation and Operation Manual
2 Driver Installation
9
10 Follow the on-screen instructions to complete
Linux
1
2
3
4
5
6
7
8
9
10 Open the Drivers folder.
11 Copy the .tgz file to a temporary folder.
12 Open a terminal window and change the
13 Extract the file using the command tar -xfz
14 Change to the directory created above then run
Follow the on-screen instructions to complete
the driver installation.
the driver installation.
Note
These steps assume a basic knowledge of
Linux terminal commands. You must also
have the correct kernel header files for the
appropriate kernel already installed.
Power on your system and log in as the
administrator or a user with proper
administrative privileges.
Go to
https://www.attotech.com/downloads/
Register or log in if previously registered.
Click on Ethernet Adapters in the left dialog.
Navigate to your HBA model/family in the right
dialog and click on it.
Scroll down to and click the desired driver
depending on the operating system.
A download window appears. Choose Save
File.
After the download has completed, open the
FastFrame volume on the desktop.
Open the Linux folder.
location of the copied tgz.
<filename.tgz>.
the installer script ./install.sh.
Advertisement
Table of Contents
