ATTO Technology FastFrame NS11 Getting Started Manual

ATTO Technology, Inc.
155 CrossPoint Parkway
Amherst, New York 14068 USA
www.attotech.com
Tel (716) 691-1999
Fax (716) 691-9353
Sales support: sls@attotech.com
Technical support: Please visit https://www.attotech.com/support/
techsupp@attotech.com (716) 691-1999 x242
© 2015 ATTO Technology, Inc. All rights reserved. All brand or product names are trademarks of their respective holders.
No part of this document may be reproduced in any form or by any means without the express written permission of ATTO
Technology, Inc.
7/2015
Thank you for purchasing the ATTO FastFrame 10GbE Network Interface Card (NIC). This
guide gives you the basics for installing and configuring your adapter. For more information,
please visit our website at
1 Overview
This guide covers hardware and software
installation, setup procedures, and
troubleshooting tips for ATTO FastFrame 10Gb
Ethernet adapters.
Ensure you have the equipment and software
you need for the installation:
• FastFrame NIC
• A computer with an available PCIe or PCIe
• Cables, connectors and SFP+ modules
for hours of operation.
PRMA-0430-000MD
FastFrame™ 10GbE Network Interface Card
Getting Started Guide
www.attotech.com
Note
This guide refers to drivers and features available on
IA-32 based computer platforms and platforms based
on Intel® Extended Memory 64-bit Technology. These
drivers are not compatible with Itanium®-based
computers.
2.0 expansion slot
2 System Requirements:
Before installing the ATTO FastFrame 10Gb
Ethernet Adapter, check your system for the
following minimum configuration
requirements.
Supported Operating Systems
Please visit https://www.attotech.com/ for an
up-to-date list of all currently supported
operating systems.
The installer for the adapter drivers will only
list the drivers that are compatible with the
currently running operating system.