Diskonchip 2000 Quick Installation Guide; Diskonchip 2000 Installation Instructions - SBC -775 Instruction Manual

DiskOnChip 2000 installation instructions

1. Make sure the target platform is powered OFF.
2. Plug the DiskOnChip
direction is correct (pin 1 of the DiskOnChip
pin 1 of the socket).
3. Power up the system.
4. During power up you may observe the messages displayed by the
DiskOnChip
the system's memory.
5. At this stage the DiskOnChip
the system.
6. If the DiskOnChip
appear as the first disk (drive C: in DOS).
7. If there are more disks besides the DiskOnChip 2000, the DiskOn-
®
Chip 2000 will appear by default as the last drive, unless it was
programmed as the first drive. (Please refer to the DiskOnChip
2000 utilities user manual.)
8. If you want the DiskOnChip
a . Copy the operating system files into the DiskOnChip
the standard DOS command (for example: sys d:).
b . The DiskOnChip
would be configured as the first disk in the system (c:) using the
DUPDATE utility.
DUPDATE D /S: DOC104.EXB /FIRST
DUPDATE C /S: DOC104.EXB
®
2000 device into its socket. Verify the
®
2000 when its drivers are automatically loaded into
®
2000 is the only disk in the system, it will
®
®
should be the only disk in the systems or
®
®
2000 can be accessed as any disk in
2000 to be bootable:
2000 is aligned with
®
by using
(set as c:)
(set as d:)
®