Sanyo DC-TS760 Service Manual page 10

SERVICE MODE
C. Setup Procedures
1. Displaying SERVICE MODE screen
Display Service Mode screen following the instructions "How to
enter Service Mode" above.
2. Displaying Internal Setup screen
Push NEXT button within three seconds after operating the
Service Mode display.
On the Internal Setup screen shown on the right, set up Market
and Region.
Model
DC-760/AU
Market/Region setup table.
3. Setting Market code
3.1. While a highlighted indicator is displayed on the right side
of the Market denotation, push ENT button on the remote
controller.
With each push the indicator will advance as shown
below.
3.2. Specify the code of the model in accordance with the
Market/Region Setup Table above.
3.3 Once the desired code is displayed, push p button to
move the highlighted indicator to the Region input area.
Market Region
AU 4
Region 0
BackendVersion S21225A1
LoaderVersion
Internal Setup
M a r k e t t
Region
00-WM 01-SFC 02-UK 03-XE
S18
05-SS 06-PA 07-AU 08-CN 09-JP
Internal Setup
M a r k e t t
Region
00-WM 01-SFC 02-UK 03-XE
S18
05-SS 06-PA 07-AU 08-CN 09-JP
- 10 -
W M
M a r k e t
55 50 05
Value
W M
00
1
Exit
W M
00
1
Exit
(Reference figure)
04-
04-