Rs232 Connection; Meridian Digital Theatre And Surround Systems - Meridian DSP5000C User Manual

If you are mixing Meridian 200- or 600-Series with 500-Series
components
1. Connect the digital and analogue audio as described in the previous
sections.
2. Locate the DIN plug at the source end of the M5-Lead. Connect it to
one of the sockets COMMS on the rear of a 500-Series unit.
3. Connect the 500-Series communications together as described earlier
and in the 500 User Guide(s).
4. Make a communications connection between one of the 500-Series
and one of the 200-Series units with a CD5 lead – obtainable from
your dealer. (The P-lead supplied with the 200-Series will work, but the
CD5 is preferred)
5. Configure the DSP5000C and 500-Series item for 200 mode (see page
30)
If you are using no other Meridian equipment
1 Connect the DSP5000C's D1 and D2 digital inputs to appropriate
digital sources
2 Configure the DSP5000C for Type 5 (see page 30)
DO NOT, under any circumstances, connect anything other than another
Meridian product to the sockets marked Comms Input and Comms
Output on the rear of the DSP5000C.

RS232 connection

The DSP5000C installation can be controlled directly from a computer
over a standard RS232 interface.
Separate documentation and application programs are available from your
Meridian dealer.

Meridian Digital Theatre and surround systems

For details on connecting a Meridian Digital Theatre, or for connecting the
DSP5000C with a Meridian 565 Digital Surround Processor, see the
handbook supplied with 565.
Connecting DSP5000C
DSP5000C User Guide
45