Table of Contents
Advertisement
CORD REPLACEMENT
See Figures 14 and 15.
Unplug your sander.
WARNING:
Failure to unplug your sander could
result in accidental starting causing possible
serious personal injury.
Remove the handle cover screws and handle
cover. Note the locations of all wiring in the handle
and how each connection is made to the switch.
Connections and wiring position must be identical
when installing new cord. See Figure 14.
SCREWS
Remove the cord clamp screws and cord clamp.
Remove the switch from the handle.
Using a small flat blade screwdriver, loosen the
screw terminal for each power cord lead. See Figure
15.
MAINTENANCE
HANDLE
COVER
SCREWS
CORD
CLAMP
BEND
RELIEF
CORD
HANDLE
Fig. 14
SWITCH
Once loose, power cord leads can easily be removed
from switch.
Remove bend relief from cord.
Place bend relief on new cord.
Make lead connections to the new cord by
inserting each lead into the screw terminals.
Tighten each screw terminal securely.
Pull on leads to check lead connections in
terminals.
Arrange the wiring in the handle so that it will not
be pinched or contact screws when the handle
cover and screws are replaced. Position the switch
in place. See Figure 14.
Place the cord and bend relief in their correct
locations. See Figure 12.
Replace cord clamp and secure with cord clamp
screws.
Tighten cord clamp screws securely.
Replace handle cover and screws.
Tighten handle cover screws securely.
16
WHITE POWER
CORD LEAD
BLACK POWER
CORD LEAD
SCREW
TERMINAL(S)
Fig. 15
Advertisement
Table of Contents
