Table of Contents
Advertisement
SWITCH REPLACEMENT
See Figures 12 and 13.
Unplug your sander.
WARNING:
Failure to unplug your sander could
result in accidental starting causing possible
serious personal injury.
Remove the handle cover screws and handle
cover. Note the locations of all wiring in the handle
and how each connection is made to the switch.
Connections and wiring position must be identical
when installing new switch. See Figure 12.
SCREWS
MAINTENANCE
HANDLE
COVER
SWITCH
HANDLE
Fig. 12
Lift the switch away from the handle.
Using a small flat blade screwdriver, loosen the
screw terminal for each switch lead. See Figure 13.
WHITE
SWITCH LEAD
YELLOW
SWITCH LEAD
Once loose, switch leads can easily be removed from
switch.
Make lead connections to the new switch by
inserting each lead into the screw terminals.
Tighten each screw terminal securely.
Pull on leads to check lead connections in
terminals.
Arrange the wiring in the handle so that it will not
be pinched or contact screws when the handle
cover and screws are replaced, then position the
switch in place. See Figure 12.
Replace handle cover and screws.
Tighten handle cover screws securely.
15
SWITCH
WHITE POWER
CORD LEAD
BLACK POWER
CORD LEAD
SCREW
TERMINAL(S)
Fig. 13
Advertisement
Table of Contents
