Operations; How To Begin - Bissell SPOTBOT PET 33N8 Series User Manual

Operations

Getting ready
1. To fill the clean water/solution tank:
a. Remove the clean water tank by lifting
it straight up and then away from the unit.
b. Unscrew the cap at the bottom of the
clean water tank.
2. Follow the fill lines on your Clean Tank
to add the correct amount of hot tap water
(140°F/60°C MAX), BISSELL Portable Machine
formula and 1 oz of BISSELL Boost.
DO NOT BOIL OR MICROWAVE WATER.
3. Tighten black cap on bottom of clean tank
and replace.

How to begin

Using the Automatic Smart System™
Your new SpotBot features an Automatic Smart
System that takes the guesswork out of spot and
stain removal. With the touch of a button, you
can select the cleaning cycle to use your pre-
ferred method of cleaning.
1. Surface Stain Cycle This cycle has been
designed for stains that are on the surface of
your carpeting. This cycle will run for approxi-
mately 3 minutes.
2. Set-In Stain Cycle Use on stains that have had
a period of time to set-in. These are typically the
most difficult stain types to remove. This cycle
runs for approximately 6 minutes.
3. Manual/Hose By selecting this option you
can clean spots and stains using the hose and
tool on surfaces such as upholstery, stairs, car
interiors, or any other hard to reach area.
4. Pause/Resume If you press the pause/resume
button once, it will pause the cleaning cycle. Press
again to resume your current cleaning cycle.
5. Stop By pressing the red stop button, you
will stop the cleaning cycle completely. To begin
cleaning again, you will need to start over and
select a cleaning cycle.
6. Status Indicator Lights Will give you a visual
update on the cleaning cycle. During a clean-
ing cycle you will hear changes in the sound of
the machine that correspond with a given step.
When the cleaning cycle is complete, the Finish
light will illuminate and you will hear a series
of "beeps". Press the STOP button to turn the
machine off. The machine will not
beep when turned off.
www.BISSELL.com
6
WARNING
Keep spray away from face. Failure to do
so may result in personal injury.
1a.
2.
Tips
» Dry vacuum the area first, before spot
cleaning with the SpotBot.
» Some spots and spills require that you
pick up the chunky debris with a rag or
towel before you begin cleaning in the
automatic or manual cycles.
1b.
3.