Display Bezel; Replacing The Display Assembly; Removing The Display Bezel - Dell Inspiron M5040 Owner's Manual

1 display cable
7. Disconnect the Mini-Card antenna cables from the connectors on the Mini-Card. See
8. Make a note of the display cable and Mini-Card antenna cables routing and remove the cables from the routing guides.
9. Remove the four screws (two on each side) that secure the display assembly to the computer base.
10. Lift and remove the display assembly out of the computer base.
1 display assembly 2 screws (4)

Replacing the Display Assembly

1. Follow the instructions in Before You
2. Place the display assembly in position and replace the four screws (two on each side) that secure the display assembly to the computer base.
3. Route the display cable and Mini-Card antenna cables through the routing guides.
4. Connect the Mini-Card antenna cables to the Mini-Card. See
5. Connect the display cable to the connector on the system board.
6. Replace the hinge cover. See
7. Follow the instructions from
8. Replace the two screws to the computer base.
9. Replace the battery. See Replacing the
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
Display Bezel

Removing the Display Bezel

1. Follow the instructions in Before You
2. Remove the display assembly. See
Begin.
Replacing the
Replacing the Hinge Cover.
step 3 to step 7 in Replacing the Palm-Rest
Battery.
Begin.
Removing the Display Assembly.
Removing the Mini-Card.
Mini-Card.
Assembly.