Break- N - TOHATSU M 4C Owner's Manual

PRE-OPERATING PREPARATIONS
3. Break-in
0 – 10 10 min –
min 3 hrs
Less
Throttle
dle than /2
Position
throttle
Cruising Approx
at 500
Speed
minimum 3 500
speed rpm
!
Operat ng the outboard motor w thout
break- n can shorten serv ce fe of the
product.
f any abnorma ty s exper enced
dur ng the break- n:
• Discontinue the operation immediately
• Have the dea er check the product
and take proper act on(s) f necessary.
After
3 – 5 hrs
5 hrs
Less Full
than 3/4
throttle
throttle available
Available
Approx to operate
4 000 at wide
rpm open
throttle
!
● During the break-in period never run
the engine continuously at high speed
● After runn ng- n s comp eted, se ect
the correct prope er so that the
eng ne speed s the recommended
range at the w de-opon thrott e.
● After comp et ng 5 hours of break-
n, rep ace the gear o w th new o .
Refer to "Chang ng the gear o " n
subsect on (2), Per od c nspect on.
Fuel mix ratio for break-in
●
!
Do not operate the outboard motor
n c osed area or area w th no forced
vent at on.
Exhaust gas em tted by th s outboard
motor conta ns carbon monox de
that w cause death f nha ed
cont nuous y. nha ng the gas n t a y
causes symptoms such as fee ng of
s ckness, drows ness and headache.
Dur ng operat on of the outboard
motor:
• Keep per phera area we vent ated.
• A ways attempt to stay on the
w ndward s de of em ss on.