Mercedes-Benz SL-Class Operator's Manual page 56

Getting started
Driving
Single wipe
Press the combination switch briefly in
direction of arrow 1.
The windshield wipers wipe one time
without washer fluid.
Wiping with windshield washer fluid
Push the combination switch in direc-
tion of arrow 1 past the resistance
point.
The windshield wipers operate with
washer fluid.
For information on filling up the washer
reservoir, see "Windshield washer system
and headlamp cleaning system"
( page 278).
54
!
If anything blocks the windshield
wipers (leaves, snow, etc.), switch
them off immediately.
For safety reasons,
turn off the engine by turning
the SmartKey to position 0 and
withdraw the SmartKey from
the starter switch
or
turn off the engine by pressing
the KEYLESS-GO* start/stop
button and open the driver's
door (with the driver's door
open, the starter switch is in po-
sition 0, same as with the
SmartKey removed from the
starter switch)
before attempting to remove any
blockage.
Remove blockage.
Turn the windshield wipers on
again.
If windshield wipers fail to function at
all in switch position I,
set the combination switch to the
next higher wiper speed
have the windshield wipers
checked at the nearest authorized
Mercedes-Benz Center