Table of Contents
Advertisement
OPERATION
TUNE
Anode capacitor for tuning, tuning of H igher frequencies to 0, Lower
Anode capacitor for tuning,
frequencies to 100 .
frequencies to 100
LOAD
Output capacitor tunes antenna load resistance to amplifier.
Output capacitor tunes antenna load resistance to amplifier.Capacity is low at
100 and high at 0
100 and high at 0 on the scale.
OFF
Power down the am
Power down the am plifier.
ON
Power up the amplifier.
a delay before the am
a delay before the am plifier is ready for operation. The
remain lit until the unit is ready for operation. Once ready
WAIT
OPR
Enables amplifier ready f
note that the WAIT indicator will need to display
note that the WAIT indicator will need to display
amplifier.
STBY
Places Amplifier into Standby Mode. The LCD panel will display
Places Amplifier into Standby Mode. The LCD panel will display
Places Amplifier into Standby Mode. The LCD panel will display
If the amplifier is
antenna. Maximum power throughput must not exceed 2 00 Watts!
antenna. Maximum
FPW
LCD Bar graph – shows
RFP
LCDBar graph –
exceeds 350W the
HV
M easures the Anode Voltage.
easures the Anode Voltage.
IA
M easures the current of the anode
easures the current of the anode in mA.
HF2013DX- A HF AMPLIFER
amplifier. Heating of tube takes 15 0 seconds, therefore there will be
the unit is ready for operation. Once ready this indicator will display
amplifier ready f or operation The LCD panel will display
is in
STBY
shows PEP output power.
shows reflected power of the antenna. If the reflected power
the amplifier switches to STANDBY-mode.
A HF AMPLIFER INSTRUCTION MANUAL
igher frequencies to 0, Lower
0 seconds, therefore there will be
The LCD panel will display
WAIT
your transceiver will be directly
Page 16 of 37
Capacity is low at
WAIT
WAIT
indicator will
indicator will display
OPR
– Please
before you can operate the
before you can operate the
STBY
directly connected to the
00 Watts!
If the reflected power
Advertisement
Table of Contents
