EarthQuake W1265V Operator's Manual page 5

• Never attempt to load your log splitter when the cylinder
wedge is in motion.
• Only use your hand to operate the control lever. Never use
your foot or a rope or any other extension device.
• Always keep fingers away from any cracks that open in the
log during splitting operation.
• Never move the log splitter while the engine is running.
• Never leave your log splitter unattended with the engine run-
ning. Shut off the engine if you are leaving your splitter, even
if for a short period of time.
• Only operate the log splitter from the operator zone (SEE
FIGURE BELOW).
• Do not operate your log splitter on slippery, wet, muddy, or
icy surfaces.
• Only operate your log splitter on level ground and not on a
hillside.
• Never attempt to move the log splitter over hilly or uneven
terrain without a tow vehicle or adequate help.
• Always block wheels to prevent movement of log splitter while
in operation.
• Do not alter your log splitter in any manner such as attaching
a rope or extension to the control lever or adding to the width
or height of the wedge.
Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5
operator zone
(European Model Shown)
Trail Warrior Quick Split 12-Ton Log Splitters
HyDRaULIC SaFETy:
• The hydraulic system and mechanical parts of your log splitter
require careful inspection. Be sure to replace any damaged
hydraulic component.
• Fluid escaping from a very small hole can be very difficult
to see. Do not check for leaks with your hand. Escaping fluid
under pressure can have sufficient force to penetrate skin,
causing serious personal injury or even death. Leaks can be
located by passing a piece of cardboard or wood over the
suspected leak. Look for discoloration.
• If injured by escaping fluid, see a doctor at once. Serious in-
fection or reaction can develop if proper medical treatment
is not administered immediately.
• Should it become necessary to loosen or remove any hydraulic
fitting or line, be sure to relieve all pressure by shutting off the
engine and moving the control handle back and forth several
times.
• The pressure relief valve on your log splitter is preset at the
factory. Do not adjust the valve. Only a qualified service tech-
nician should perform this adjustment.
Operator's Manual
5