Table of Contents
Advertisement
Step 13: Attach top panel [A] to left upper side panel [I] and right upper side panel [J]
with 4 KD screws. See Fig. M.
Step 14: Attach 4 door hinges [Rr] to left and right doors [Q and R] with 8 door
mounting screws [Ru]. Attach 2 door handles [Rs] to left and right doors
[Q and R] with 2 handle screws [Rt]. See Fig. N.
Step 15: Attach left and right door [Q and R] to left outer side panel [C] and right outer
side panel [D] with 8 door mounting screws [Ru]. See Fig. O.
Fig. M
Fig. N
Fig. O
FIREPLACE INSERT INSTALLATION:
The fireplace insert can be installed after the mantel has been fully assembled.
WARNING: Make sure the fireplace insert controls are in the OFF position and the
unit is NOT plugged in.
Step 16: Carefully place the insert into the unit opening. The front of insert should be
flush with the front of the mantel. See Fig. P.
Step 17: Once the insert is in place, attach 2 L-mounting brackets [T] with 2 medium
KD screws [V] onto base panel [B] (1 screw for each bracket). Attach 4 short
KD screws [U] to the top of insert. See Fig. Q.
Step 18: Tighten all KD screws.
Step 19: Carefully move the assembled unit to the desired location. The fireplace
mantel should not be positioned in area exposed to direct sunlight.
WALL ANCHOR SAFETY CABLE
The use of wall anchor safety cable is highly recommended in order to reduce the
risk of the fireplace being tipped over accidentally. WARNING: This cable may reduce
possible risk of injury if the fireplace is improperly handled, but is not a substitute for
proper adult supervision. Children should not be left unattended near any heater.
Step 1: Drill a 5/16 in (8 mm) hole in the wall. Insert the plastic wall anchor into the
hole and gently tap until the flange on the anchor is against the wall surface.
Step 2: Position the back edge of the mantel close to the wall.
Step 3: Attach the safety cable to the mantel using the screw for mantel.
Step 4: Use the screw for wall to attach the other end of safety cable to the wall.
Step 5: Make sure all screws are tight.
5
Fig. P
Fig. Q
Advertisement
Table of Contents
