Door Removal; Li~Ht: Bulb Replacement; Surface Units; Control Knobs - GE JDC27GP Use And Care Manual

–
To
REMOVE door. open to
BROIL position, or where yoLl feel
hinge catch slighlly. Grasp door at
sides: lift door up and away from
hinges.
To REPLACE. grasp door at sides.
Line up door with hinges tind push
Lift-Up Cooktop
Clean [he area under the cooktop
grease. may catch tire.
To make cleaning easier, the entire
cooktop may be lifted up and
supported by the support rod that
catches and holds the
top
Lip.
turned off before
raising the
front sides
cooktop. Grasp the
After cleaning the cooktop
clean cloth, pu[ the cooktop buck
in place. &
your fingers.
Brushed Chrome Finish
(on models so equipped)
Clean the brushed chrome top
with warm, soapy water or an all-
purpose househo!d cletiner and
soft cloth. Take care to dry the
surface following the "grain ." To
help prevent finger marks after
cleaning, spread a thin film of
oil on the surface. Wipe away
excess oil with a clean, soft cloth.
A good appliance wax will help
protect this finish.
Oven Light Bulb
The light bulb is located on the rear
wall of the oven. Before replacing
the bulb. disconnect electric power
to the range at the main fuse or
circuit breaker panel or unplug the
range from the electric outlet. Let
the bulb cool completely before
bulb with a damp cloth. If yoLl do,
the bulb will break.
Never touch the electrically live
collar on the bulb when replacing it.
when it's
To remove:
Unscrew and 1 ift off the glass
cover. Remove the bulb.
To replace:
Put in a new 40-watt appliance
bulb.
A 40-watt appliance bulb
is smaller than a standard 40-watt
pinch
household bulb. We recommend
Replace imd tighten the cover.
Reconnect electrical power to
the
range.
NOT REMOVE SCREWS.
Outer Enamel Finish
models so equipped)
(on
The porcelain enamel cooktop is
sturdy but breakable if misused.
This finish is acid-resistunt.
high in acid (such as fruit juices,
tomato or vinegar) should not be
permitted to rcrnain on the finish.

Surface Units

Clean the area under the drip pans
often. Bui]t-up soil, especially
grease, may catch fire. To make
cleaning easier, plug-in units are
removable.
Caution: Be sure all controls are
turned to OFF and surface units
are cool before attempting to
remove them.
units and clean them according to
directions in the Cleaning Guide.
Wipe around the edges of the
surface unit openings. Clean the
area below the units. Rinse till
washed areas with a damp cloth
sponge.
or

Control Knobs

The control knobs may be removed
for cleaning.
To remove knob, pull it straight
remove, place a thin cloth (like a
handkerchief) or a piece of string
under and around the knob edge
and pu]] Lip.
Wash knobs in soap and water but
do not soak.
To replace knob, locate the
stem. One of the grooves contains
is clear. Locate the molded rib
inside the knob. Fit the molded
bulb that is
rib of the knob into the clear groove
on the knob stem.
Make sure to replace the single
oven control knob on the correct
knob stem.
the knob
Of
23