Table of Contents
Advertisement
Practical hints
Flat tire
Version 1
a Vent screw
b Pressure gauge
Close vent screw a on pressure
gauge b (version 1 only).
Screw filler hose 8 onto tire valve 9
( page 403).
Insert electrical plug 4 ( page 403)
into the cigarette lighter ( page 256).
Turn the SmartKey in the starter switch
to position 1 ( page 37).
404
Press I on electric air pump switch 3
( page 403).
The electric air pump is switched on
and inflates the tire.
i
First, the sealing is pumped into the tire. The
pressure may briefly rise to up to 73 psi (5 bar).
This is normal and not an indication of a malfunc-
tion. Do not switch off the electric air pump.
Let the electric air pump inflate the tire
for approximately 5 minutes.
The pressure gauge must display at
least 26 psi (1.8 bar). The air hose can
become hot during inflation.
Please exercise appropriate caution.
!
Do not operate the electric air pump longer
than 6 minutes without interruption. Otherwise it
may overheat.
You may operate the air pump again after it has
cooled off.
If the tire inflation pressure of at least
26 psi (1.8 bar) is not attained, turn off
the electric air pump by pressing 0 on
electric air pump switch 3
( page 403).
Detach filler hose 8 from tire valve 9
( page 403).
Drive vehicle back and forth very slowly
approximately 30 ft (10 m).
This serves to better distribute the
TIREFIT sealant material inside the tire.
Unscrew the air pump's air hose 5
from flange 6 of TIREFIT container 1
( page 403).
Screw air hose 5 onto tire valve 9.
Inflate the tire again.
Advertisement
Table of Contents
