Table of Contents
Advertisement
Available languages
Available languages
5. Use Iris
Iris is not included when the projector leave factory, user can purchase the iris if he needed. Loose the
screws and insert the iris.
6. Replacing fuse
•
Before replacing the fuse, unplug mains lead.
•
Procedure:
Step 1: Unscrew the fuseholder on the rear panel with a fitting screwdriver from the housing (anti-
clockwise).
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing and fix it.
7. Focus
•
The objective lens cylinder is usually shrinked before leaving factory, after connect the projector to the
mains, user may loose the screws and pull out the lens cylinder, till the light output circular is clearly
presented, locking tightly the two screws again.
•
When the projection distance is changed, user can follow previous operating steps and focus the
projector.
14
Advertisement
Table of Contents
