Mercedes-Benz 2005 M-Class Operator's Manual page 165

One after the other, press the two
mounting hooks 2 inward against the
spring pressure and turn them.
The mounting hooks are locked in this
position and you can move the net into
position more easily.
Turn one of the mounting hooks 2 in
the opposite direction.
The spring pressure will push it out.
Engage mounting hook 2 in
holder 1.
Turn the other mounting hook and en-
gage it in the opposite holder.
Push both mounting hooks 2 forward
into holder 1.
Tightening partition net
i
Before tightening the partition net,
remove the cargo floor plates
( page 165).
Installation behind the front seats
1 Tie-down hook
2 Ring
Controls in detail
Installation behind the rear seats
1 Tie-down hook
2 Ring
3 Tensioner
Insert tie-down hook 1 in rings 2.
Pull on loose ends of tie-down straps
until net is tight.
After driving a short distance, check
the tension on the net and retighten if
necessary.
Loading
163