Table of Contents
Advertisement
NOTE:You may need the Microsoft Windows Operating System installation files (CAB
files) to complete the installation. The CAB files are contained in the Microsoft's system
CD-ROM. Some systems may have already installed the CAB files to the hard drive, but
you should have the CD-ROM handy just in case.
1.
The New Hardware Found window will
detect the ADSL modem card as a PCI
Network Controller. Select the Driver
from disk provided by hardware
manufacturer option. Click OK.
2.
Insert the ADSL Driver CD-ROM into
your systems CD drive.
3.
The Install From Disk window appears.
Click Browse to locate the driver on your
CD-ROM for the protocol supported by
your ADSL provider:
2364w95
or
1577w95
"D" as the CD-ROM drive letter. Your
drive may have a different letter.) Then
click OK.
4.
When the Service Option window
appears, click Advanced.
5.
The Service Options window displays
the Connection Address and Select
ADSL Mode sections. Enter in the VPI,
VCI and Framing values supplied by
your ADSL service provider.
In the Select ADSL Mode section, select
the mode(s) recommended by your ADSL
service provider. Click on the mode(s)
required and then click OK.
NOTE: The service mode type will be one of
the following:❑ ANSI T1.413 Issue 2
❑ ITU G.992.2 Annex A(G.lite)
❑ ITU G.992.1 Annex A(G.dmt)
1483w95
or
(The example uses
RFC 1577
RFC 2364
RFC 1483
6
Advertisement
Table of Contents
