Advertisement
1. Assemble Shelf
A. Align and attach the shelf to the cord wrap bracket with (4) 8-32 x 3/8" PHM
screws as shown in Figure 1.
B. Using the narrow slots as guides, apply (6) 3" x 2" adhesive Velcro
pads (hook side) to the top of the shelf as shown.
Note: If you have the shelf
only (no hubs) skip to step 4.
8-32 x 3/8" PHMS
(4) req'd
cord wrap
bracket
2. Install USB Hubs
®
A.
Apply a 3" x 2" Velcro
pad (loop side) to the bottom of each USB hub.
B.
Attach the 6 hubs to the top of the shelf. Figure 2.
Attach the feeder (Hub #7) to the bottom of the shelf 90 ° to the other hubs as shown.
C.
Note: The single feeder hub under the shelf distributes the data stream to the other
6 hubs.
D.
Power cords and USB cables can be secured to the shelf with the included zip ties, and
cord wrap bracket.
E.
See the hub installation guide included with the hubs for further operational, connection,
and setup info.
Figure 2
shelf
Figure 1
(hubs only included with #55444)
Hub #2
Hub #1
®
Hub #4
Hub #3
narrow slot
®
adhesive Velcro
pads
(6 on top of shelf, one
under shelf)
Hub #6
Hub #5
shelf
®
adhesive Velcro
pad
"Feeder" USB Hub #7
mounted at 90 ° angle
under shelf
0110562R4 Page 2 of 8
Advertisement
