Getting Started; Accessory List; Turning Power On And Off; Detaching And Attaching The Front Panel - Alpine iDA-X303 Owner's Manual

01GB00iDAX303.book Page 6 Wednesday, October 29, 2008 11:19 AM

Getting Started

Double Action encoder
SOURCE
/ENTER

Accessory List

• Digital Media Receiver.......................................................1
• Power cable ........................................................................1
• USB cable ...........................................................................1
• Interface cable for iPod .....................................................1
• Mounting sleeve.................................................................1
• Carrying case .....................................................................1
• Bracket key.........................................................................2
• Screw (M5x8)......................................................................4
• Owner's Manual .......................................................... 1 set

Turning Power On and Off

Press SOURCE to turn on the unit.
• The unit can be turned on by pressing any other button except
(Release), Double Action encoder and VIEW. The unit is also
automatically turned on if a USB memory/iPhone/iPod is connected.
Press and hold SOURCE for at least 2 seconds to turn
off the unit.
• The first time power is turned on, the volume will start from level 12.

Detaching and Attaching the Front Panel

Detaching
1
Turn off the unit power.
2
Press (Release) at the middle left side until the
front panel pops out.
3
Grasp the left side of the front panel and pull it out.
• The front panel may become hot in normal usage (especially the
connector terminals on the back of the front panel). This is not a
malfunction.
• To protect the front panel, place it in the supplied carrying case.
6
-EN
01GB05iDAX303.fm
Attaching
1
Insert the right side of the front panel into the main
unit. Align the groove on the front panel with the
projections on the main unit.
2
FUNCTION/SETUP
Push the left side of the front panel until it locks
firmly into the main unit.
VIEW
• Before attaching the front panel, make sure that there is no dirt or
dust on the connector terminals and no foreign object between the
front panel and the main unit.
• Attach the front panel carefully. Hold the panel by its sides to avoid
pushing any buttons by mistake.

Initial System Start-Up

Be sure to press the RESET switch when using the unit for the first
time, after changing the car battery, etc.
1
Turn off the unit power.
2
Press
3
Press RESET with a ballpoint pen or similar pointed
object.

Adjusting Volume

Turn the Double Action encoder until the desired
sound is obtained.
(Release) to remove the front panel.
ALPINE iDA-X303 68-14470Z02-A (EN)