Operating Instructions - Equinox Systems Promo Spot EQLED86 User Manual

Operating instructions

Gobo carriage
Gobo replacement:
The Promo Spot is supplied with 11 steel gobo's. To replace the gobo
first power off the fixture and leave to cool. Isolate the fixture from the
mains voltage supply. On the underside of the unit remove the two
Gobo Retaining clip
thumbscrews and withdraw the gobo carriage from the fixture. Carefully
remove the circlip holding the gobo in place, then remove the gobo and
replace with the new gobo. Install the gobo retaining circlip and reinstall
the gobo carriage into the fixture. Replace the thumbscrews taking care
to tighten them fully. Power on the fixture and adjust focus as required.
Securing thumbscrews
Retaining clip
Users may change the gobos supplied for a custom design of their own. Custom gobos can be made of
metal, glass or user printed onto standard transparency film. The image size for custom gobos should be
no greater than 23mmØ and the overall size of the gobo should be 28.5mmØ.
Please note: Gobos printed using standard transparency film (up to 1mm) should be for temporary use
only up to a maximum of 6-8 hours. Gobo's printed with heavy black print may heat up faster and last
for a shorter length of time before the gobo will require replacement.
www.prolight.co.uk Promo Spot User Manual
5