Bang & Olufsen BEOLAB PENTA Owner's Manual page 11

12 MODE switch
Once connected to the mains sup-
ply, the Beolab Penta is in the
stand-by mode. The stand-by
mode is indicated by a red light
on the front of the amplifier unit.
The speaker switches on auto-
matically when it receives a signal,
unless, of course, the MODE
switch is set to OFF. When the
speaker switches on, the light on
the front of the amplifier turns
green.
Set the MODE switch to either
AUTO, L (left) or R (right):
Sockets
POWER LINK
Left speaker
Right speaker
SPEAKER LINK
Receiver without
built-in loudspeaker
relay
Receiver with
built-in loudspeaker
relay
LINE IN
When the signal disappears, the
speaker automatically switches
off, i.e. reverts to the stand-by
mode, after a delay of approx. 10
seconds (MODE switch in L or R
position) or approx. 3 minutes
(MODE switch in AUTO position).
MODE
switch
L
R
AUTO
L / R
AUTO