Dodge Avenger 2013 Owner's Manual page 221

HOTOIL
When this message is displayed there is a engine oil
over-temperature condition. When this condition occurs,
the "HOTOIL" message will be displayed in the odom-
eter along with a chime.
Refer to "If Your Engine Overheats" in "What To Do In
Emergencies".
gASCAP
If the vehicle diagnostic system detects a leak or change
in the evaporative system, or the fuel filler cap is loose,
improperly installed, or damaged, the words "gASCAP"
will display in the odometer display area. If this occurs,
tighten the fuel filler cap properly and press the odom-
eter reset button to turn off the "gASCAP" message.
(Refer to "Onboard Diagnostic System — OBDII" in
"Maintaining Your Vehicle" for further information).
UNDERSTANDING YOUR INSTRUMENT PANEL 219
If the problem continues, the message will appear the
next time the vehicle is started. See your authorized
dealer service center as soon as possible.
CHANgE OIL
Your vehicle is equipped with an engine oil change
indicator system. The "CHANgE OIL" message will flash
in the instrument cluster odometer for approximately
12 seconds after a single chime has sounded to indicate
the next scheduled oil change interval. The engine oil
change indicator system is duty cycle based, which
means the engine oil change interval may fluctuate
dependent upon your personal driving style.
Unless reset, this message will continue to display each
time you turn the ignition switch to the "ON" position.
To turn off the message temporarily, press and release the
Trip Odometer button on the instrument cluster. To reset
4