Advertisement
FRONT PANEL
GAIN LOW/HI Switches OUTPUT Mode Selector
MIC 1/LINE/MIC 2
⑤
⑥
Selectors
③
Output Peak LED
Input Level
Controls
LEFT-SIDE PANEL
AUX (R) Input
⑬
Jack
RTN Input Jacks
⑭
⑯
PHONES Jack
OUTPUT Jack
BOTTOM PANEL
PHANTOM
⑲
Switches
Bat ery Compartment
⑰
⑦ ⑧
Monitor Selector
POWER indicator
②
④
①
POWER Switch
⑨
MONITOR Level
Control
⑳
MIC 2 Input
⑫
Camera Mounting Screw
Jack
⑪
⑩
Ch-R XLR Input
⑮
Ch-L XLR Input
⑱
AGC Switch
Threaded Hole
21
⑳
for Tripod
Camera Mountin
⑳
Bolt
4
POWER Switch
○
1
POWER Indicator LED: Green indicates power on and good bat ery condit on. Red indicates low bat ery voltage.
○
2
Ch-L, Ch-R Input Volume Level Controls
○
3
Output Peak Indicator LED: When the output volume level is too high and the sound is distorted, the LED will light in RED.
○
4
Reduce the volume level by turning the Input Volume Level Controls ○
MIC 1/LINE/MIC 2 Selectors: Selects microphone or line level input on each channel.
○
5
GAIN LOW/HI Switches: Change the gain level of each channel. Refer to the specif cati ns for the actual gain level of LOW/HI
○
6
for each input mode.
OUTPUT Mode Selector: Selects the output mode between mono and stereo.
○
7
○
Monitor Selector: Selects headphone monitoring from either the microphones during recording (OUTPUT) or playback audio
8
from the camera (RTN).
MONITOR Level Control: Adjust the headphone volume level.
○
9
Ch-R and Ch-L XLR Inputs: Two balanced XLR inputs at ach to microphones or other audio gear such as wireless systems
○
&○
10
11
or sound boards.
○
MIC 2 Stereo Input: 3.5mm mini-plug jack that, when a stereo microphone is connected, will distribute the sound to the both
12
L & R channels. When a monaural microphone is connected, the sound will be sent to Ch-L. Provides 3.5V input power.
AUX (R) Input: Unbalanced 3.5mm mini-plug jack for connect ng to a wireless receiver or other device that has a mini-plug
○
13
output cable. The sound will be sent to Ch-R. This input cannot be used simultaneously with the Ch-R XLR input (○
RTN Inputs: RCA jacks for connect ng AV cable to the camera to monitor the audio during playback.
○
14
○
OUTPUT Jack: Unbalanced 3.5mm mini-plug jack for connect ng to the camera. MIC level output.
15
PHONES jack: Headphone jack to monitor the audio from microphones or camera.
○
16
○
Bat ery Compartment
17
AGC ON/OFF Switch: When turned OFF, disables the Audio Gain Control feature in the camera. Read "Using AGC ON/OFF
○
18
Feature" in this manual before using this functio .
Phantom Switch: Act vates 48V phantom power.
○
19
Camera Mount Bolt
○
20
Thread Hole for Tripod
○
21
counterclockwise.
3
).
10
5
Advertisement
