Installing The Camera; Mounting The Bracket To The Camera - Eminent EM6250 Easy Pro View Manual

The major components on the back panel of the EM6250 are the bracket screw jack,
power jack, Ethernet jack and reset button:
1. Bracket screw jack – this is the position to screw in the bracket of the EM6250.
With the bracket, you can put the EM6250 on the desk, on the wall or on the
ceiling.
2. Power jack – this is the place to plug in the power adapter. The power needed for
this EM6250 is 12V/1.0A or 5V/1A, please make sure you are using the correct
power adapter.
3. Ethernet jack – this is the place to plug in the RJ45 Ethernet cable. When the
Ethernet link is ok, the Ethernet indication LED on the front side will be blue light.
4. Reset button – this is the button to reset the EM6250 to default factory settings.
You need to use a small stick like pencil or tooth stick to press the reset button for
more than 3 seconds to enable the reset function. Usually when you forgot the
administrator account, you will probably need to do this reset action to reset to the
default factory settings. Please refer to section 5.6.6 for more details.

2.0 Installing the camera

A few short and simple steps are necessary to connect and assign the camera, and to
enjoy the use of the camera. Use the following steps to connect the camera.

2.1 Mounting the bracket to the camera

6 |
ENGLISH