Asus TUWE-M 810E2 MICROATX MOTHERBOARD User Manual page 32

3. HARDWARE SETUP
11) Primary (Blue) / Secondary IDE Connectors (Two 40-1pin IDE)
These connectors support the provided IDE hard disk ribbon cable. Connect the
cable's blue connector to the motherboard's primary (recommended) or second-
ary IDE connector, and then connect the gray connector to your UltraATA/100
slave device (hard disk drive) and the black connector to your UltraATA/100
master device. It is recommended that non-UltraATA/100 devices be connected
to the secondary IDE connector. If you install two hard disks, you must config-
ure the second drive to Slave mode by setting its jumper accordingly. Please
refer to your hard disk documentation for the jumper settings. BIOS now sup-
ports specific device bootup (see 4.6 Boot Menu). (Pin 20 is removed to pre-
vent inserting in the wrong orientation when using ribbon cables with pin
20 plugged).
TIP: You may configure two hard disks to be both Masters with two ribbon
cables – one for the primary IDE connector and another for the secondary IDE
connector. You may install one operating system on an IDE drive and another on
a SCSI drive and select the boot disk through 4.6 Boot Menu.
IMPORTANT:
UltraDMA/100 IDE devices must use a 40-pin 80-conductor IDE
cable for 100MByte/sec transfer rates.
®
TUWE-M
TUWE-M IDE Connectors
32 ASUS TUWE-M User's Manual
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
PIN 1