Charging Swimmer; Factory Reset - Polk Mono BOOM Swimmer Duo Owner's Manual

Charging Your Swimmer
While charging your Swimmer the LED will turn red. The red LED will
then turn off when your battery is fully charged.
It takes about two hours to fully charge your Swimmer, giving you six to
eight hours of uninterrupted music playing at full volume.
Maintaining Your Waterproof Seal
Swimmer Duo: Ensure that that the attachment (suction cup or tail)
is fully screwed into place until it's tight. If your attachment is not fully
screwed into place, your Swimmer only will be water-resistant—not
waterproof.
Swimmer Jr. : Ensure the rubber flap covering the micro USB port is
fully pushed in and flush with the body of your Swimmer Jr.
Locking the Tail Into Place
To lock your Swimmer's flex tail into place after
you've looped it around the object of your
choice, loop the end of the tail through the
open slot at the tail's base and twist the tail's
tip to the right or left.
www.boommovement.com

Factory Reset

If you're having any connectivity issues, you may need to perform a
factory reset of your Swimmer. To do that, press the +/- buttons at
the same time for about eight seconds. An audible cue will be heard
after three seconds, followed by the LEDs flashing blue and red after
about eight seconds. You will notice the LED indicator flashing every
two seconds and waiting to be discovered and paired in Bluetooth
mode afterwards.
Swimmer Owner's Manual
4