Odours; Light (Led); Tips For Saving Energy - Siemens KG36VVW30G Instructions For Use Manual

Hide thumbs Also See for KG36VVW30G:
Table of Contents

Advertisement

Removing the container
Fig. 5
Pull out the container all the way, lift at
the front and remove.
Vegetable drawer
(not all models)
The fascia of the vegetable drawer can
be removed for cleaning.
Press side buttons in succession
and remove fascia from the vegetable
drawer. Fig. /
Take out shelves in the door
Fig. 9
Lift shelves upwards and take out.

Odours

If you experience unpleasant odours:
1. Switch off the appliance with the On/
Off button. Fig. 2/1
2. Take all food out of the appliance.
3. Clean interior (see chapter "Cleaning
the appliance").
4. Clean all packages.
5. Seal strong smelling food in order
to avoid odours from forming.
6. Switch the appliance on again.
7. Store food in the appliance.
8. Check whether the formation
of odours is still occuring after
24 hours.

Light (LED)

Your appliance features a maintenance-
free LED light.
These lights may be repaired
by customer service or authorised
technicians only.

Tips for saving energy

Install the appliance in a dry, well
ventilated room! The appliance should
not be installed in direct sunlight
or near a heat source (e.g. radiator,
cooker).
If required, use an insulating plate.
Allow warm food and drinks to cool
down before placing in the appliance.
Thaw frozen food in the refrigerator
compartment and use the low
temperature of the frozen food to cool
refrigerated food.
Regularly defrost the freezer
compartment to remove the layer
of frost.
A layer of hoarfrost will impair
refrigeration of the frozen food
and increase power consumption.
Open the appliance as briefly as
possible.
Occasionally clean the rear
of the appliance to prevent an
increased power consumption.
If available: Fit wall spacers to obtain
the indicated energy rating of the
appliance (see Installation
instructions). A reduced wall gap will
not restrict the function of the
appliance. The energy rating may then
change slightly. The gap of 75 mm
must not be exceeded.
en
15

Advertisement

Table of Contents
loading

Table of Contents