Husqvarna 555FX Operator's Manual page 73

Temperature -5°C (23°F) or colder
Dismantle the machine's wear guard, and fit the wear
guard from the winter kit as shown in the figure. Pay
particular attention that the opening on the air duct is
positioned in the centre of the hole in the air filter holder.
IMPORTANT! If the temperature rises above -5°C
(23°F) or 0°C (32°F) respectively the machine MUST be
restored to its normal set-up. Otherwise there is a risk of
overheating, which can cause severe engine damage.
Lubrication of wire
(555FXT)
The wire is pre-lubricated and does not need to be
lubricated again until required.
• Remove the protective cover.
• Unscrew the cylinder cover and make sure the rubber
bellows on the wire has not been expanded too much.
• Unscrew the plug on the grease nipple.
MAINTENANCE
• Use antifreeze spray with a 2 mm spray tube. Spray in
short bursts.
• Fit covers.
IMPORTANT! Any maintenance other than that
described in this manual must be carried out by your
servicing dealer (retailer).
IMPORTANT! Use only HUSQVARNA replacement
parts. Use of other brands of replacement parts can
cause damage to your unit or injury to the operator or
others. Your warranty does not cover damage or liability
caused by the use of accessories and/or attachments
not specifically recommended by HUSQVARNA.
–
English 73