Led Operation - B&B IE-Giga-MiniMc Operation Manual

Powering the IE-Giga-MiniMc
IE-Giga-MiniMc supports multiple powering options.
• A country-specific AC power adapter (included)
• The 4-terminal DC power block
• IE-PowerTray/18
• Dual USB cable
• IE-Power/5V DIN rail mount power supply

LED Operation

Each IE-Giga-MiniMc converter includes two LEDs, located on the RJ-45 connector.
LED functions are as follows:
LED functions are as follows (above illustration is representative):
FX LNK/ACT Glows green when a link is established on the fiber port; blinks
green when activity is detected on the fiber port.
TX LNK/ACT Glows amber when a link is established on the copper port; blinks
amber when activity is detected on the copper port.
FX TX
4
DC Terminal Block Wiring Instructions
The IE-Giga-MiniMc can be powered via the DC terminal block. From a power
source, connect to any one positive and any one negative terminal on IE-Giga-
MiniMc.
Connected to Chassis
When using stranded wire, the leads must be tinned and equivalent to a 16 AWG solid
conductor. The DC terminal block is protected against mis-wiring. If the unit is mis-wired,
positive power lead to the negative terminal and negative power lead to the positive
terminal, it will not function. When powering a unit with voltages near the upper limit of
the device's specification (for example: 48 volts) take precautions to limit the voltage at the
units terminal block. When turning on high voltage DC circuits, initial voltages may
momentarily exceed the unit's specification.
NOTE
5