Installing The Ie-Giga-Minimc; Hardware Mounting Options - B&B IE-Giga-MiniMc Operation Manual

Installing the IE-Giga-MiniMc

The IE-Giga-MiniMc installs virtually anywhere as a standalone device in locations
with extremely limited space. Installation options include:

Velcro strips
 DIN rail mounting with DIN Rail clips

A wall mount bracket

An IE-PowerTray/18 for high density applications
Installation Tip
Several models of the IE-Giga-MiniMc support single-strand fiber for operation. Since
single-strand fiber products use optics that transmit and receive on two different
wavelengths, single-strand fiber products must be deployed in pairs. For example,
connect an IE-Giga-MiniMc, TX/SSLX-SM1310-SC (which has 1310 xmt and 1550 rcv) to a
product which has 1550 xmt and 1310 rcv, e.g. iMcV-Gigabit, TX/SSLX-SM1550-SC. The
two connected products must also have the same speed and distance capabilities (i.e.
both are single-mode [20km] or both are single/PLUS [40km]).
2

Hardware Mounting Options

The IE-Giga-MiniMc can be mounted on a DIN rail or using wall mount brackets
(shown below).
DIN rail clips (part number 806-39105) and wall mount brackets (part number 895-
39229) are available for purchase through an B&B Electronics Distributor.
DIN Rail Clips
The DIN Rail clips include screws, to allow
the installation onto a DIN Rail. Install the
screws into DIN Rail clips, which should be
mounted parallel or perpendicular to the DIN
Rail. Snap the converter onto the clips. To
remove the converter from the DIN Rail, use
a flat-head screwdriver into the slot to gently
pry the converter from the rail.
The DIN clips are designed for use on a DIN-35 rail.
NOTE
3