2.7
Switches and jumpers
2.7.1 Switches
The following figure shows the location and default settings of the DIP
switches on the motherboard.
Keep the default settings for stable system operation.
PR-DLS
PR-DLS DIP Switches
2.7.2 Jumpers
1. SCSI setting (2-pin SCSI_EN)
This jumper allows you to enable or disable the onboard SCSI feature.
Keep the jumper open if you wish to install SCSI devices. Place a cap
on the jumper to disable the onboard SCSI controller.
PR-DLS
PR-DLS SCSI Setting
2-14
CLKSW
ON
ON
OFF
1 2 3 4 5
(Default)
SCSI_EN
Enable
Disable
(Default)
Chapter 2: Hardware information