RX-V663/HTR-6160/DSP-AX763
Writing method using PC (RS232C)
G Required Tools
•
Windows 2000/XP, PC with a serial port (RS232C)
•
Firmware downloader program
For microprocessor:
DSP_FLASHER_v3.0_M16C80.exe
For DSP (TI flash ROM):
DSP_FLASHER Ver2.7.exe
•
Firmware
For microprocessor:
VX63xxxx.mot
For DSP (TI flash ROM):
Vx63_data1_verxxxxxr.hex
•
RS232C cross cable "D-sub 9 pin female"
(Specifications)
Pin No.2 RxD
Pin No.3 TxD
Pin No.5 GND
Pin No.7 RTS
Pin No.8 CTS
•
RS232C conversion adapter (Including flexible
flat cable 9P, 300mm) / Part no.: AAX77610
G Preparation and precautions before starting
the operation
•
Download firmware upgrading program and firm-
ware from the specified source to the same folder
of the PC.
•
Prepare the above specified RS232C cross cable.
•
While writing, keep the other application software
on the PC closed.
It is also recommended to keep the software on
the task tray closed as well.
G Operation Procedures
Writing to the microprocessor
•
Writing firmware
1. Turn off the power of this unit and disconnect the
power cable from the AC outlet.
24
● 必要なツール
Pin No.2 RxD
Pin No.3 TxD
Pin No.5 GND
Pin No.7 RTS
Pin No.8 CTS
● 操作前の準備と注意
● 操作手順
・ ファームウェアの書き込み
PC (RS232C) を使用して書き込む方法
・ Windows 2000/XP、シリアルポート (RS232C)
付きPC
・ ファームウェア書き込み用プログラム
マイコン用:
DSP_FLASHER_v3.0_M16C80.exe
DSP (TI flash ROM) 用:
DSP_FLASHER Ver2.7.exe
・ ファームウェア
マイコン用:
JX63xxxx.mot
DSP (TI flash ROM) 用:
Vx63_data1_verxxxxxr.hex
・ RS232Cクロスケーブル "D-sub 9pin" メス
(仕様)
Pin No.2 RxD
Pin No.3 TxD
Pin No.5 GND
Pin No.7 RTS
Pin No.8 CTS
・ RS232C変換アダプター (カード電線 9P、300mm
含む) /部品番号:AAX77610
・ PCへ指定のダウンロード先からファームウェア
アップグレードプログラムおよび、ファームウェ
アを同じフォルダにダウンロードしてください。
・ RS232Cクロスケーブルは必ず上記仕様のものを
用意してください。
・ 書き込み時は、PC上の他のアプリケーションソフ
トは閉じてください。
さらに、タスクトレイ上にあるソフトも閉じてお
くことを推奨します。
マイコンへの書き込み
1. 本機の電源を切り、電源コードをACコンセントか
ら抜きます。
Pin No.2 RxD
Pin No.3 TxD
Pin No.5 GND
Pin No.7 RTS
Pin No.8 CTS