Running-In Instructions; Care And Maintenance; Cowls - LML Speedy 4-Stroke Owner's Manual

ENGINE RUNNING-IN
Operation : The most important period in the life
of your scooter is its first 1000 kms. The engine
is brand new and different moving parts of the
engine need to be set to their correct operating
tolerances. This ensures a longer life for your
vehicle. It is therefore necessary to take some
precautions so as not to overload the engine.
1. Keep to the following speed limits
1st Gear : 0 to 10 kms/hr.
2nd Gear : 10 to 20 kms/hr.
3rd Gear : 20 to 35 kms/hr.
4th Gear : 35 kms/hr and above.
2. Avoid running the scooter on full accelerator
(throttle) for long periods. Vary the speed from
time to time.

CARE AND MAINTENANCE

1. REMOVAL AND REFITTING OF COWLS :
The right hand side cowl is to be removed for
checking of oil level and spark plug. The left hand
side cowl is to be removed for taking out or refitting
the spare wheel.
The levers for opening the cowls are placed
under the seat. To remove the cowls:
1.1 Lift the seat as explained on page 21.
1.2 Turn the cowl opening levers outwards
(Fig. 34).
1.3 Hold the cowl with both hands and pull
out the front end of the cowl by about
2". Then push the front end upwards by
about 10" and rotate it outwards i.e.
towards its rear side (Fig. 35 & 36).
1.4 Pull out the cowl by disengaging its rear
end. (Fig. 37).
1.5 Refit the cowl, by following above
procedure in reverse.
3. Do not drive with half (partially engaged)
clutch. This will not only damage the clutch
but will also cause overheating of the
engine.
4. Allow a cooling off period of 5-10 minutes
after each hour of use.
5. Ensure oil level in engine to recommended
level, by checking the level with the help of
dipstick.
Running-in-Instructions
3 1
Care and Maintenance
3 2