Internal Connectors - Asus P5W DH User Manual

2.7.2

Internal connectors

1. Floppy disk drive connector (34-1 pin FLOPPY)
This connector is for the provided floppy disk drive (FDD) signal cable. Insert
one end of the cable to this connector, then connect the other end to the
signal connector at the back of the floppy disk drive.
Pin 5 on the connector is removed to prevent incorrect cable connection when
using a FDD cable with a covered Pin 5.
P5W DH DELUXE Floppy disk drive connector
2. JMicron IDE connector (40-1 pin PRI_EIDE [black])
®
This connector is for Ultra ATA 133/100/66 signal cables. The JMicron
connector supports up to two IDE hard disk drives for easier data storage.
P5W DH DELUXE IDE connector
This connector does not support ATAPI devices.
ASUS P5W DH Deluxe
®
PRI_EIDE
®
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
FLOPPY
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
PIN 1
IDE
®
PIN 1
2-