•
• •
•
• •
• •
•
• •
• •
• •
• •
•
• •
•
• •
• •
• •
• •
•
It
• •
I
ft
Page 24
7) Focus video microscope on sample's surface.
8) Using the "Pre-Scan" software "Manual Z Motor Control," move motor to sample, probe just out of focus.
9) In the AFM-View "Pre-Scan" window,
initia~e
"Automated Tip Approach." Wait for the green light to indicate
•
•
I
that feedback was achieved. '.
9a) If the "Z Drive" indicator is not at the center of its range, start tip approach again.
10) With the "Scan" tab at the top of the AFM-View window, open the "Scan" window.
•
10
•
8
9
•
•
a