Asus P5N32-E SLI Hardware User Manual page 53

P5N32-E SLI Plus
P5N32-E SLI Plus IDE connector
3. Serial ATA connectors (7-pin SATA1-6)
These connectors are for the Serial ATA signal cables for Serial ATA hard disk
drives.
If you installed Serial ATA hard disk drives, you can create a RAID 0, RAID
1, RAID 0+1, RAID 5, or JBOD configuration with the onboard NVIDIA
MediaShield™ RAID controller.
The RAID function of these connectors is set to [Disabled] by default. If you
intend to create a Serial ATA RAID set using these connectors, enable the RAID
Enabled item under the Serial ATA Configuration sub-menu in the BIOS. See
section "4.5.3 Onboard Device Configuration" for details.
P5N32-E SLI Plus
P5N32-E SLI Plus SATA connectors
These connectors support Native Command Queuing (NCQ), Power
Management (PM) Implementation Algorithm, Hot Swap and smart setup.
ASUS P5N32-E SLI Plus
®
PIN 1
SATA2
®
SATA1
PRI_IDE
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
with the onboard NVIDIA
SATA4 SATA6
SATA3 SATA5
®
2-27