Table of Contents
Advertisement
3 Initial Operation
Setting up the Device
Place the projector on a flat surface in front of the
projection surface. In case you need to tilt the device
slightly upwards (e.g.: when using a tripod) you can
correct the distortion by using the built-in keystone
correction.
Connect Power Supply /
Charge Battery
Power is supplied through the power supply (included),
one end is connected to the power jack on the rear side
of the device, the other end to the AC100~240V wall
outlet.
Navigation for settings menu
Navigation can be done by navigation keys (¡/¢/À/
Á/à and
).
Navigation keys:
1 ¡/¢ scrolls trough the menu level up and down.
à goes one level down, with
In the final level, à accepts a setting and automati-
cally returns to the last submenu.
2 The
key aborts a setting and automatically
returns to the last submenu (or exits the menu
depending on the menu-level ).
8
Initial Installation
1 Push the POWER
power indicator turns to green to turn the device
on.
2 Turn the device towards a suitable projection sur-
face or wall. Note that the distance to the projection
surface must be a minimum of 0.5 meters and a max-
imum of 5 meters. Make sure the projector is in a
secure position.
3 Use the focus wheel on the right side to adjust the
image sharpness.
4 The first time you turn on the device, you should fin-
ish the main settings.
Setup Language
In order to change the menu language, proceed as
follows:
1 When the device is turned on, press the à button
to enter Settings.
one level up.
2. Select Language with ¡/¢ buttons.
3. Confirm with à.
4. Select your desired language with ¡/¢ buttons.
5. Confirm with à.
6. Press
Image settings
Keystone
Use À/Á buttons to correct a distorted image.
Projection mode
Front: Normal projection; the device is located in front
of the projection surface/ screen.
Rear: Rear projection; the device is located behind the
projection surface, the image is horizontal mirrored.
Ceiling: The device is hanging from the ceiling in an
upside down position; the image is rotated by 180
degrees.
Rear ceiling: The device is hanging from the ceiling in
an upside down position behind the projection surface,
button for 3 seconds till the
Settings
Image Settings
Sound Settings
Power Save
Language
Flashlight
SOS Light
Warning Light
Maintenance
to return to the menu one level up.
Philips PPX 4835
1/1
Advertisement
Table of Contents
