11. ASSEMBLY HINTS
•
The D COVER should be mounted before the A COVER. Be careful that the sides
of the D COVER fit into the A COVER.
•
You might need to slightly bend the keymat shield locks inwards to make them hook
on to the C COVER.
•
The camera gasket has glue on both sides and might break in two when the D
COVER is removed (half stays on the D COVER and the other half on the camera).
If this happens, remove the old parts of the gasket from both the D COVER and the
camera using a pair of tweezers and mount a new gasket on the D COVER. If the
gasket is not damaged during disassembly, it can be reused.
•
If the camera has been removed, you can wait to replace it until just before the D
COVER cover is mounted. In this way, it is protected during re-assembly.
•
If the UI FLEX has been completely removed, it must be replaced with a new one. It
is possible to replace the DC connector just by carefully lifting up the corner of the
UI FLEX.
•
In general, be very careful not to damage the microphone located on the side of the
UI FLEX (next to the camera switch).
•
When replacing the UI FLEX, it can be aligned by holding the C COVER up and
then aligning the UI FLEX (before attaching it) by looking through the holes in the
FLEX and C COVER. Attach the FLEX when the holes fit (light shines through the
holes).
•
When removing the camera, the camera tool might have scratched off some very
small particles from the camera sides. To remove such particles before placing a
new camera, please turn the phone upside down and after that blow into the socket
with compressed air so that any residue from the old camera is removed.
•
When mounting the A COVER, make sure that the A COVER hooks are correctly in
place on the C COVER. If necessary, press the hooks towards the C COVER after
the A COVER is mounted.
24
Confidential
Copyright @ 2008 NOKIA. All rights reserved
6700 classic RM-470
Service Manual Level 1&2
ISSUE 3