Table of Contents
Advertisement
LevelOne
Hardware Reset
The reset button is used to reset the system or restore the factory default settings. Sometimes
resetting the system can return the camera to normal operation. If the system problems remain
after rebooting, restore the factory settings and install again.
Reset: Press and release the reset button with a paper clip or thin object. Wait for the Network
Camera to reboot.
Restore: Press and hold the reset button until the status LED rapidly blinks red and green
simultaneously. Note that all settings will be restored to factory default.
SD Card Capacity
This network camera is compliant with SD/SDHC 16GB / 8GB and other preceding standard SD
cards.
Status LED
The color of LED indicates the status of the Network Camera.
Item
Steady Red
1
Red LED unlighted
Steady Red + Blink Green every 1 sec.
2
Steady Red + Green LED unlighted
3
Steady Red + Blink Green every 2 sec.
4
Blink Red every 0.15 sec. + Blink Green every 1 sec.
5
Blink Red every 0.15 sec. + Blink Green every 0.15 sec. Restore default
6 - User Manual
LED status
Reset Button
Description
Power on and system booting
Power off
Network works (heartbeat)
Network fail
Audio mute (heartbeat)
Upgrading Firmware
Advertisement
Table of Contents
