Asus P4SDR-VM User Manual page 44

8. Infrared module connector (5-1 pin IR1)
This connector supports an optional wireless transmitting and receiving
infrared module. This module mounts to a small opening on system
chassis that support this feature. You must also configure the UART2
Use As parameter in BIOS to set UART2 for use with IR. See section
"4.4.2 I/O Device Configuration" for details.
Use the five pins as shown in Back View and connect a ribbon cable
from the module to the motherboard SIR connector according to the
pin definitions. (NOTE: The infrared module is purchased separately.)
P4SDR-VM
®
P4SDR-VM Infrared Module Connector
9. Front panel audio connector (10-1 pin FPAUDIO1)
(on audio models only)
This is an interface for the Intel front panel audio cable that allow
convenient connection and control of audio devices.
P4SDR-VM
®
P4SDR-VM Intel Panel Connector
2-22
Front View
IR1
1
FPAUDIO1
2 10
1 9
Chapter 2: Hardware information
Back View
+5V
IRTX
GND (NC)
IRRX