2. IDE connectors (0-1 pin PRI_IDE, SEC_IDE)
The onboard IDE connectors are for Ultra DMA 133/100/66 signal cables.
There are three connectors on each Ultra DMA 133/100/66 signal cable:
blue, black, and gray. Connect the blue connector to the motherboard's IDE
connector, then select one of the following modes to configure your device(s).
Single device
Two devices
•
Pin 20 on the IDE connector is removed to match the covered hole on the
Ultra DMA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
•
Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.
If any device jumper is set as "Cable-Select," make sure all other device
jumpers have the same setting.
P5V-VM
ULTRA
P5V-VM ULTRA IDE Connectors
ASUS P5V-VM Ultra Motherboard
Drive jumper
setting
Cable-Select or Master
Cable-Select
Master
Slave
PIN 1
Mode
of devices
-
Black
Master
Black
Slave
Gray
Master
Black or gray
Slave
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
Cable
connector
1-25